ILDA распиновка | Pangolin Laser Systems
Dealer registration

ILDA распиновка

The chart below lists pins for the ILDA DB-25F female connector. This connector conforms to the ILDA DB-25 connector standard. The ILDA standard uses differential signals for projector inputs, primarily because they are more immune to noise. For example, you will see X+ and X- signals defined below. The positive indicates a normal signal; the negative indicates an inverted signal. Projectors also use differential signals for color signals as well, but generally outputs only single-ended OUTPUT signals for colors. This is allowed by the ILDA Standard.

db25f ILDA pin-out

ILDA DB25 connector

Signal name

Pin

 Notes
X+ 1  -5V to +5V
Y+ 2  -5V to +5V
Intensity/Blanking + 3  0V to +2.5V
Interlock A 4 Connected to pin 17 inside the QM2000
R+ 5 Red, 0V to +5V
G+ 6 Green, 0V to +5V
B+ 7 Blue (typically 476 nm), 0V to +5V
Deep blue + 8 Violet (typically 457 nm), 0V to +5V
Yellow + 9 Yellow, 0V to +5V
Cyan + 10 Brightest blue (usually 488 nm cyan), 0V to +5V
Z+ 11 Depth Z (not intensity), -5V to +5V
Not connected 12  
Shutter 13  0V to +5V (referenced to Ground pin 25)
X- 14  -5V to +5V
Y- 15  -5V to +5V
Intensity/Blanking – 16 Connected to Ground pin 25
Interlock B 17 Connected to pin 4 inside the QM2000
R- 18 Connected to Ground pin 25
G- 19 Connected to Ground pin 25
B- 20 Connected to Ground pin 25
Deep blue – 21 Connected to Ground pin 25
Yellow – 22 Connected to Ground pin 25
Cyan – 23 Connected to Ground pin 25
Z- 24  -5 to +5V
Ground 25  

Note on interlock lines A and B

The purpose of the two interlock lines is so that a projector can tell when it is properly connected to an ILDA-compatible signal source. The projector will put a current or signal into pin 4. The same current or signal should be present back at the projector when reading pin 17.

Найти учебные материалы по лазерам
Определения лазерного шоу (что означают отраслевые термины)

Новости

Образование

Заряжено Pangolin